Operator's Manual

23
2. Swing the rear access cover to the right (Fig. 18).
m–4670
Figure 18
Closing the Rear Access Cover
1. Swing the rear access cover to the left and seat it in
place over the back of the traction unit.
2. Place the latch over the locking bracket (Fig. 18).
3. Pull the latch rearward and push it in to lock it in place
(Fig. 18).
Removing the Side Screens
1. Open the hood.
2. Slide the side screens (Fig. 19) up and out of the slots
in the front screen and frame.
m–4738
1
Figure 19
1. Side screen 2. Locking tab
Installing the Side Screens
Slide the side screens (Fig. 19) into place in the slots in
the front screen and frame.
Removing the Front Screen
If the engine has been running the heat shield will
be very hot and could burn you.
Allow the traction unit cool completely before
touching the heat shield.
Caution
1. Open the hood and remove both side screens.
2. Loosen the bolts securing the front weight (Fig. 20).
m-5236
2
1
3
4
Figure 20
1. Front weight
2. Bolts
3. Heat shield
4. Carriage bolts
3. Remove the carriage bolts and nuts securing the heat
shield (Fig. 20).
4. Lift the heat shield up and off of the traction unit.
5. Remove the 4 bolts securing the front screen to the
traction unit frame and remove the front screen
(Fig. 21).
2
1
m-5239
Figure 21
1. Front screen 2. Bolts (left side bolt not
shown)