Service Manual

Rev. 000
HYDRAULIC LIFT ASSEMBLY
7-32
TX 413 Service Manual
17. Lift the loader arm assembly from the unit (Fig.
303).
Figure 303 DSC-1060
16. With a hammer and a long pipe, tap the pivot pin
out of the loader arm assembly (Fig. 302).
Figure 302 DSC-1058
14. Remove the two vent hoses, located above
the oil filter bracket. The top vent is for the fuel
tank (A) and the bottom vent is for the hydraulic
reservoir tank (B) (Fig. 300).
Figure 300 DSC-1064
15. Remove the bolt and nut at pivot pin for the
loader arm assembly (Fig. 301).
Figure 301 DSC-1057
A
A
B
B
B
A. Tilt cylinder hoses B. Auxiliary hoses
A
A