Service Manual

ATTACHMENTS
10-2 TX 413 Service Manual
Rev. 001
Auger Removal
Fig 001 CLR DSC-0220
Fig 002 CLR DSC-0213
2. While lowering the arms, drive slowly backwards
until the auger is horizontal (Fig. 002).
Fig 004 CLR DSC-0218
5. Start the engine and back the traction unit away from
the auger bit (Fig. 004).
Note: If you used an extension, remove the bolt and
nut securing it and pull it off the auger shaft.
Fig 003 CLR DSC-0217
3. Stop the engine.
4. Remove the bolt and nut securing the auger bit or
extension to the auger shaft (Fig. 003).
1. To remove the auger bit from the auger shaft, set the
assembly down in its storage location (Fig. 001).