Service Manual

ATTACHMENTS
10-11TX 413 Service Manual
Rev. 001
Fig 036 CLR DSC-0142
11. Reposition the auger housing so the shaft end faces
down. Use a bearing driver or a hammer and punch
to remove the second bearing from the housing (Fig.
036).
Note: Check the bearings for smooth rotation. If
damaged by dirt or debris, replace bearing.
Remove Power Head from Frame
Assembly
1. From the operator’s position, mark the pivot plates
with R for right and L for left before disassembly.
2. The auger housing has a right and left side and
should be marked accordingly before disassembly.
3. Remove the three bolts and nuts securing one of
the pivot plates to the frame assembly (Fig. 037).
Fig 037 CLR DSC-0148