Service Manual

Rev. 000
MAINTENANCE
Greasing the Traction Unit
Grease all pivot joints every 8 operating hours and
immediately after every washing.
Grease Type: Lithium based NLGI2
1. Lower the loader arm and stop the engine.
Remove the key from the ignition switch.
2. Clean the grease fittings with a rag.
3. Connect grease gun to each fitting and pump
grease into the fittings until grease begins to ooze
out of the bearings (approximately 3 pumps).
4. Wipe any excess grease.
There are 11 grease fittings on the TX413: (3) are
located on the left side (Fig. 001).
Figure 001 DSC-0764
Figure 002 DSC-0766
(1) is located under the hood for the loader arm
assembly (Fig. 002).
(5) are located in the front on the quick attachment
assembly and the front loader arm assembly (Fig.
003).
Figure 003 DSC-0767
3-2
TX 413 Service Manual