Service Manual

Rev. 000
ELECTRICAL SYSTEM
Neutral Proximity Switch
Used to ensure the traction control lever is in the
neutral/stop position when starting the unit. It is a
magnetic type switch and it must be in proximity with
the traction control lever bolt to close the contacts
(Fig. 095).
Figure 095 MVC-0878X
5-6
TX 413 Service Manual
Purpose
The hour meter is located under the hood, toward
the dash assembly (Fig. 093).
Figure 093 DSC-0755
Location
The hour meter is an electronic digital clock.
It has its own internal battery to keep memory of
the hours, when the engine is not running. It is not
repairable or resettable.
How It Works
1. Verify that 12 volts is present across the two
terminals when the key is in the "RUN" position.
Since the meter is polarized, it is important the
positive wire is connected to the correct terminal (Fig.
118).
2. When the meter is operating properly, the
hourglass icon will be flashing on and off. If the
hourglass icon is not showing and the meter is
hooked up properly, replace the meter (Fig. 094).
Testing
Hour Meter
The hour meter keeps track of how long the
key has been in the "RUN" position. Also, the hour
meter has a Maintenance Reminder Program. Icons
will flash 3 hours before the service interval through
3 hours after the service interval. The service icon
(looks like an hourglass) is set-up to flash at 8 hours
(Break-in Period) and then every 99 hours.
At every 399 hour interval a second icon will
flash. The "SVC" icon is a reminder to change the
hydraulic oil and filter.
Purpose
Figure 094 MVC-0877X
A
B