Operator's Manual

Setup
Step
1
Charging the Battery
No Parts Required
Procedure
Warning
CALIFORNIA
Pr oposition 65 W ar ning
Batter y posts, ter minals, and r elated
accessories contain lead and lead
compounds, chemicals kno wn to the State of
Calif or nia to cause cancer and r epr oducti v e
har m. W ash hands after handling .
1. Open the rear access co v er .
2. Connect a c harg er to the batter y ( Figure 2 ) and
c harg e it for a minim um of 1 hour at 6 to 10
amps . Do not o v erc harg e the batter y .
1
2
3
4
G003792
Figure 2
1. Positive post
3. Charger red (+) wire
2. Negative post
4. Charger black (—) wire
Charging the batter y pr oduces gasses
that can explode.
Nev er smok e near the batter y and k eep
spar ks and flames a w ay fr om batter y .
3. W hen the batter y is fully c harg ed, unplug
the c harg er from the electrical outlet, then
disconnect the c harg er leads from the batter y
posts ( Figure 2 ).
4. Close the rear access co v er .
Step
2
Checking Fluid Levels
No Parts Required
Procedure
Before star ting the engine for the first time , c hec k
the engine oil and h y draulic fluid lev els . R efer to
Operation for more infor mation.
12