Form No. 3420-668 Rev A Adjustable Forks TX 1000 Compact Utility Loaders Model No. 22341—Serial No. 401900000 and Up Register at www.Toro.com.
WARNING Model No. CALIFORNIA Proposition 65 Warning This product contains a chemical or chemicals known to the State of California to cause cancer, birth defects, or reproductive harm. Use of this product may cause exposure to chemicals known to the State of California to cause cancer, birth defects, or other reproductive harm. Serial No.
Slope Safety Safety • Operate the machine up and down slopes with the heavy end of the machine uphill. Weight distribution changes with attachments. An empty attachment makes the rear of the machine the heavy end, and a full attachment makes the front of the machine the heavy end. Most other attachments make the front of machine the heavy end. General Safety Always follow all safety instructions to avoid serious injury or death.
Attachment Safety Safety and Instructional Decals • Always lower the attachment each time you shut off the machine or leave the operating position. Safety decals and instructions are easily visible to the operator and are located near any area of potential danger. Replace any decal that is damaged or missing. • Clean any dirt or debris that may hinder connecting the attachment to the machine. Ensure that the attachment-locking pins are fully seated in the holes of the attachment-mount plate.
Setup Loose Parts Use the chart below to verify that all parts have been shipped. Procedure 1 Description Use Qty. 1 2 1 7 7 Adjustable-forks frame Fork Upper fork frame Bolt (3/8 x 1 inch) Locknut (3/8 inch) Assemble the forks. 1 Assembling the Forks Parts needed for this procedure: 1 Adjustable-forks frame 2 Fork 1 Upper fork frame 7 Bolt (3/8 x 1 inch) 7 Locknut (3/8 inch) Procedure 1.
Product Overview Operation Note: Always use the traction unit to lift and move the attachment. Important: Before installing the attachment, ensure that the mount plates are free of any dirt or debris and that the pins rotate freely. If the pins do not rotate freely, grease them. Before installing or removing the attachment, position the machine on a level surface; refer to the Operator’s Manual for the traction unit for the installation procedure.
Storage 1. Before long-term storage, wash the attachment with mild detergent and water to remove dirt and grime. 2. Paint all scratched or bare metal surfaces. Note: Paint is available from your Authorized Service Dealer. 3. Store the attachment in a clean, dry garage or storage area. Cover it to protect it and keep it clean.
