Form No. 3430-855 Rev B Adjustable Forks TX 1000 Compact Tool Carriers Model No. 22341—Serial No. 404797000 and Up Register at www.Toro.com.
WARNING Model No. CALIFORNIA Proposition 65 Warning Use of this product may cause exposure to chemicals known to the State of California to cause cancer, birth defects, or other reproductive harm. Serial No. This manual identifies potential hazards and has safety messages identified by the safety-alert symbol (Figure 2), which signals a hazard that may cause serious injury or death if you do not follow the recommended precautions.
Safety • Establish your own procedures and rules for operating on slopes. These procedures must include surveying the site to determine which slopes are safe for machine operation. Always use common sense and good judgment when performing this survey. General Safety Always follow all safety instructions to avoid serious injury or death. • Do not transport an attachment with the arms raised. Always transport the attachment close to the ground; refer to Transport Position (page 6).
Safety and Instructional Decals • When lifting the attachment keep it level and prevent the load from spilling backward. • Inspect the forks for damage after each use. Safety decals and instructions are easily visible to the operator and are located near any area of potential danger. Replace any decal that is damaged or missing. Maintenance and Storage Safety • Check fasteners at frequent intervals for proper tightness to ensure that the equipment is in safe operating condition.
Setup Loose Parts Use the chart below to verify that all parts have been shipped. Procedure 1 Description Use Qty. 1 2 1 7 7 Adjustable-forks frame Fork Upper fork frame Bolt (3/8 x 1 inch) Locknut (3/8 inch) Assemble the forks. 1 Assembling the Forks Parts needed for this procedure: 1 Adjustable-forks frame 2 Fork 1 Upper fork frame 7 Bolt (3/8 x 1 inch) 7 Locknut (3/8 inch) Procedure 1.
Operation Product Overview Installing and Removing the Attachment Refer to the Operator’s Manual for the traction unit for the installation and removal procedure. Important: Before installing the attachment, position the machine on a level surface, ensure that the mount plates are free of any dirt or debris, and ensure that the pins rotate freely. If the pins do not rotate freely, grease them. Note: Always use the traction unit to lift and move the attachment.
Operating Tips Storage • To adjust the forks, slide them along the frame to the desired width. Adjust the forks to the widest possible setting to ensure that the load is as stable as possible. 1. Before long-term storage, wash the attachment with mild detergent and water to remove dirt and grime. • When transporting a load, keep the forks as close 2. Paint all scratched or bare metal surfaces. to the ground as possible.
California Proposition 65 Warning Information What is this warning? You may see a product for sale that has a warning label like the following: WARNING: Cancer and Reproductive Harm—www.p65Warnings.ca.gov. What is Prop 65? Prop 65 applies to any company operating in California, selling products in California, or manufacturing products that may be sold in or brought into California.