Form No. 3398-473 Rev A Adjustable Forks Compact Utility Loaders Model No. 22341—Serial No. 315000001 and Up Model No. 23164—Serial No. 315000001 and Up Register at www.Toro.com.
WARNING CALIFORNIA Proposition 65 Warning This product contains a chemical or chemicals known to the State of California to cause cancer, birth defects, or reproductive harm. Use of this product may cause exposure to chemicals known to the State of California to cause cancer, birth defects, or other reproductive harm. Figure 2 1. Safety-alert symbol This manual uses 2 words to highlight information.
Safety and Instructional Decals Safety Improper use or maintenance by the operator or owner can result in injury. To reduce the potential for injury, comply with these safety instructions and those in the traction unit Operator's Manual. Always pay attention to the safety-alert symbol, which means Caution, Warning, or Danger—personal safety instruction. Failure to comply with the instruction may result in personal injury or death.
Setup Loose Parts Use the chart below to verify that all parts have been shipped. Procedure 1 Description Use Qty. 1 2 1 7 7 Adjustable-forks frame Fork Upper fork frame Bolt (3/8 x 1 inch) Locknut (3/8 inch) Assemble the forks. 1 Assembling the Forks Parts needed for this procedure: 1 Adjustable-forks frame 2 Fork 1 Upper fork frame 7 Bolt (3/8 x 1 inch) 7 Locknut (3/8 inch) Procedure 1.
Stability Ratings Product Overview To determine the degree of slope you can traverse with the adjustable installed on a traction unit, find the stability rating for the hill position you want to travel in the appropriate table below, then find the degree of slope for the same rating and hill position in the Stability Data section of the traction unit Operator’s Manual. Important: The forks are rated for use with the counterweight.
Operation WARNING Exceeding the maximum slope can cause the traction unit to tip. If the traction unit tips, you or bystanders could be crushed. Installing the Forks on the Traction Unit Do not drive the traction unit on a slope steeper than the maximum slope. Important: Before installing the attachment, ensure that the mount plates are free of any dirt or debris and that the pins rotate freely.
Storage WARNING If you do not fully seat the quick-attach pins through the attachment-mount plate, the attachment could fall off the traction unit, crushing you or bystanders. 1. Before long-term storage, wash the attachment with mild detergent and water to remove dirt and grime from the entire attachment. 2. Paint all scratched or bare metal surfaces. Paint is available from your Authorized Service Dealer. Ensure that your quick-attach pins are fully seated in the attachment-mount plate. 3.
Toro Compact Utility Equipment Warranty Compact Utility Equipment (CUE) Products A One-Year Limited Warranty Conditions and Products Covered Items and Conditions Not Covered The Toro Company and its affiliate, Toro Warranty Company, pursuant to an agreement between them, jointly warrant your Toro Compact Utility Equipment (“Product”) to be free from defects in materials or workmanship.
