Form No. 3430-859 Rev B High Volume Bucket TX 1000 Compact Tool Carriers Model No. 22342—Serial No. 404700000 and Up Register at www.Toro.com.
WARNING CALIFORNIA Proposition 65 Warning Use of this product may cause exposure to chemicals known to the State of California to cause cancer, birth defects, or other reproductive harm. g240343 Figure 1 Introduction 1. Model and serial number location The bucket is a load-bearing attachment intended to be used on a Toro tool carrier. It is designed primarily for moving rock, dirt, sand, or other materials.
Contents Safety Safety ....................................................................... 3 General Safety ................................................... 3 Slope Safety ....................................................... 3 Bucket Safety ..................................................... 4 Maintenance and Storage Safety........................ 4 Safety and Instructional Decals .......................... 5 Product Overview .....................................................
Bucket Safety load-bearing attachment makes the rear of the machine the heavy end, and a full load-bearing attachment makes the front of the machine the heavy end. Most other attachments make the front of machine the heavy end. • Wear gloves, eye protection, long pants, substantial slip-resistant footwear, and hearing protection during operation or while adjusting or repairing the machine. • Keep the attachment in the lowered position • Always lower the attachment and shut off the when on slopes.
Safety and Instructional Decals Product Overview Specifications Safety decals and instructions are easily visible to the operator and are located near any area of potential danger. Replace any decal that is damaged or missing. Note: Specifications and design are subject to change without notice. Width 132 cm (53 inches) Length 74 cm (29 inches) Height 43 cm (17 inches) Weight 115 kg (253 lb) Capacity decal133-0221 133-0221 SAE struck capacity 0.25 m3 (9.0 ft3) Heaped capacity 0.30 m3 (10.
Operation Material Density Material Density (Approximate) Caliche 1250 kg/m3 (78 lb/ft3) Determine the left and right sides of the machine from the normal operating position. Clay: Natural bed 1600 kg/m3 (104 lb/ft3) Dry 1480 kg/m3 (93 lb/ft3) Wet 1660 kg/m3 (104 lb/ft3) With gravel, dry 1420 kg/m3 (89 lb/ft3) With gravel, wet 1540 kg/m3 (96 lb/ft3) Installing and Removing the Attachment Refer to the Operator’s Manual for the traction unit for the installation and removal procedure.
Storage 1. Before long-term storage, wash the attachment with mild detergent and water to remove dirt and grime. 2. Paint all scratched or bare metal surfaces. Note: Paint is available from your Authorized Service Dealer. 3. g266856 Figure 3 Transport Position When transporting a load, keep the attachment as close to the ground as possible, no more than 15 cm (6 inches) above the ground. Tilt it rearward to keep the load level. g240205 Figure 4 1. No more than 15 cm (6 inches) above the ground 2.
California Proposition 65 Warning Information What is this warning? You may see a product for sale that has a warning label like the following: WARNING: Cancer and Reproductive Harm—www.p65Warnings.ca.gov. What is Prop 65? Prop 65 applies to any company operating in California, selling products in California, or manufacturing products that may be sold in or brought into California.
