Form No. 3450-616 Rev A Standard and Low Profile Bucket TX 1300 Compact Tool Carriers Model No. 22345—Serial No. 400000000 and Up Model No. 22346—Serial No. 400000000 and Up Register at www.Toro.com.
WARNING CALIFORNIA Proposition 65 Warning Use of this product may cause exposure to chemicals known to the State of California to cause cancer, birth defects, or other reproductive harm. g240343 Figure 1 Introduction 1. Model and serial number location The bucket is a load-bearing attachment intended to be used on a Toro tool carrier. It is designed primarily for moving rock, dirt, sand, or other materials.
Contents Safety Safety ....................................................................... 3 General Safety ................................................... 3 Slope Safety ....................................................... 4 Bucket Safety ..................................................... 4 Maintenance and Storage Safety........................ 4 Safety and Instructional Decals .......................... 5 Product Overview .....................................................
Slope Safety a safe distance between the machine and any hazard. • Operate the machine up and down slopes with • Do not remove or add attachments on a slope. the heavy end of the machine uphill. Weight distribution changes with attachments. An empty load-bearing attachment makes the rear of the machine the heavy end, and a full load-bearing attachment makes the front of the machine the heavy end. Most other attachments make the front of machine the heavy end.
Safety and Instructional Decals Product Overview Specifications Safety decals and instructions are easily visible to the operator and are located near any area of potential danger. Replace any decal that is damaged or missing. Note: Specifications and design are subject to change without notice. Model Model 22345 Model 22346 Width 121 cm (47.8 inches) 121 cm (47.8 inches) Length 61 cm (24.0 inches) 68 cm (26.7 inches) Height 41 cm (16.2 inches) 32 cm (12.
Operation Material Density Material Density (Approximate) Caliche 1250 kg/m3 (78 lb/ft3) Determine the left and right sides of the machine from the normal operating position. Clay: Natural bed 1600 kg/m3 (104 lb/ft3) Dry 1480 kg/m3 (93 lb/ft3) Wet 1660 kg/m3 (104 lb/ft3) With gravel, dry 1420 kg/m3 (89 lb/ft3) With gravel, wet 1540 kg/m3 (96 lb/ft3) Installing and Removing the Attachment Refer to the Operator’s Manual for the traction unit for the installation and removal procedure.
Storage 1. Before long-term storage, wash the attachment with mild detergent and water to remove dirt and grime. 2. Paint all scratched or bare metal surfaces. Note: Paint is available from your Authorized Service Dealer. 3. g266856 Figure 3 Transport Position When transporting a load, keep the attachment as close to the ground as possible, no more than 15 cm (6 inches) above the ground. Tilt it rearward to keep the load level. g240205 Figure 4 1. No more than 15 cm (6 inches) above the ground 2.
California Proposition 65 Warning Information What is this warning? You may see a product for sale that has a warning label like the following: WARNING: Cancer and Reproductive Harm—www.p65Warnings.ca.gov. What is Prop 65? Prop 65 applies to any company operating in California, selling products in California, or manufacturing products that may be sold in or brought into California.
