Form No. 3430-867 Rev A Loose Materials Bucket Compact Tool Carrier Model No. 22410—Serial No. 403154786 and Up Register at www.Toro.com.
WARNING Model No. CALIFORNIA Proposition 65 Warning Use of this product may cause exposure to chemicals known to the State of California to cause cancer, birth defects, or other reproductive harm. Serial No. This manual identifies potential hazards and has safety messages identified by the safety-alert symbol (Figure 2), which signals a hazard that may cause serious injury or death if you do not follow the recommended precautions. Introduction g000502 Figure 2 1.
Safety distribution changes with attachments. An empty load-bearing attachment makes the rear of the machine the heavy end, and a full load-bearing attachment makes the front of the machine the heavy end. Most other attachments make the front of machine the heavy end. DANGER There may be buried utility lines in the work area. Digging into them may cause a shock or an explosion. • Keep the attachment in the lowered position when on slopes.
Bucket Safety Safety and Instructional Decals • Wear gloves, eye protection, long pants, substantial slip-resistant footwear, and hearing protection during operation or while adjusting or repairing the machine. Safety decals and instructions are easily visible to the operator and are located near any area of potential danger. Replace any decal that is damaged or missing. • Always lower the attachment and shut off the machine each time you leave the operating position.
Product Overview Material Density Specifications change without notice. 122 cm (48 inches) Length 66 cm (26 inches) Height 46 cm (18 inches) Weight 79 kg (175 lb) 0.18 m3 (6.4 ft3) Heaped capacity 0.24 m3 (8.
Operation Determine the left and right sides of the machine from the normal operating position. Installing and Removing the Attachment Refer to the Operator’s Manual for the traction unit for the installation and removal procedure. Important: Before installing the attachment, position the machine on a level surface, ensure that the mount plates are free of any dirt or debris, and ensure that the pins rotate freely. If the pins do not rotate freely, grease them.
Storage 1. Before long-term storage, wash the attachment with mild detergent and water to remove dirt and grime. 2. Paint all scratched or bare metal surfaces. Note: Paint is available from your Authorized Service Dealer. 3. Store the attachment in a clean, dry garage or storage area. Cover it to protect it and keep it clean.
California Proposition 65 Warning Information What is this warning? You may see a product for sale that has a warning label like the following: WARNING: Cancer and Reproductive Harm—www.p65Warnings.ca.gov. What is Prop 65? Prop 65 applies to any company operating in California, selling products in California, or manufacturing products that may be sold in or brought into California.
