Installation Instructions



The T

oro Company – 1998

Printed in USA

FORM NO. 3321-509

INSTALLATION

INSTRUCTIONS

Model 22451

Screw Anchor Adaptor

for Dingo Traction Units with an Auger Drive Head

Loose

Parts

DESCRIPTION QTY. USE

Screw

anchor adaptor

Install on auger drive head

Hitch pin

Hairpin cotter

Attach to a screw anchor

arranty Registration Card

Installation Instructions

Read before use

Installing

the Screw Anchor

Adaptor

1. Attach the auger drive head to the traction unit.

2. Slide the screw anchor adaptor onto the drive

head shaft and secure it with the attachment bolt

and nut supplied with the drive head (Fig. 1).

m–3995

Figure 1

1. Auger

drive head

Screw anchor adaptor

Bolt and nut

PAGE 1
FORM NO. 3321-509 Screw Anchor Adaptor for Dingo Traction Units with an Auger Drive Head INSTALLATION INSTRUCTIONS Model 22451 Loose Parts DESCRIPTION QTY. Screw anchor adaptor 1 Hitch pin 1 Hairpin cotter 1 Warranty Registration Card 1 Installation Instructions 1 USE Install on auger drive head Attach to a screw anchor Read before use Installing the Screw Anchor Adaptor 1. Attach the auger drive head to the traction unit. 2.
PAGE 2
Installation Instructions Operating the Screw Anchor Adaptor 1. Insert the eye of the screw anchor into the screw anchor adaptor and secure it with the supplied hitch pin and hairpin cotter (Fig. 2). 3 4 1 2 m–3997 Figure 2 1. Screw anchor adaptor 2. Screw anchor 3. Hitch pin 4. Hairpin cotter 2. Drive to the site where the screw anchor is to be installed and lower the point to the ground. 3. Run the engine at low speed and place the pump starter valve in the fast (rabbit) position. 4.