Form No. 3430-930 Rev A Trench Filler Compact Tool Carrier Model No. 22472—Serial No. 404320000 and Up Register at www.Toro.com.
This product complies with all relevant European directives. For details, please see the Declaration of Incorporation (DOI) at the back of this publication. WARNING CALIFORNIA Proposition 65 Warning Use of this product may cause exposure to chemicals known to the State of California to cause cancer, birth defects, or other reproductive harm. g259358 Figure 1 1. Model and serial number location Model No. Introduction Serial No.
Safety Contents Safety ....................................................................... 3 General Safety ................................................... 3 Slope Safety ....................................................... 4 Trench Filler Safety............................................. 4 Maintenance and Storage Safety........................ 4 Safety and Instructional Decals .......................... 5 Product Overview .....................................................
Slope Safety Trench Filler Safety • Operate the machine up and down slopes with • Stay in the operator’s position behind the control the heavy end of the machine uphill. Weight distribution changes with attachments. This attachment makes the front of machine the heavy end. panel while operating the trench filler. • Do not overload the machine capacity by attempting to backfill too fast.
Safety and Instructional Decals Safety decals and instructions are easily visible to the operator and are located near any area of potential danger. Replace any decal that is damaged or missing. decal107-9378 decal93-7321 107–9378 93–7321 1. For more information read the Operator’s Manual. 1. Cutting/dismemberment hazard of hands and feet, rotating knives—stay away from moving parts. 2. Keep the center arrow on the trench filler attachment decal centered over the trench when operating.
Operation Product Overview Installing and Removing the Attachment Refer to the Operator’s Manual for the traction unit for the installation and removal procedure. Important: Before installing the attachment, position the machine on a level surface, ensure that the mount plates are free of any dirt or debris, and ensure that the pins rotate freely. If the pins do not rotate freely, grease them. Note: Always use the traction unit to lift and move g013187 Figure 3 1. Float guide 4. Bearing 2.
Transport Position CAUTION Hydraulic couplers, hydraulic lines/valves, and hydraulic fluid may be hot. If you contact hot components, you may be burned. When transporting the attachment, keep it as close to the ground as possible, no more than 15 cm (6 inches) above the ground. Tilt it rearward. • Wear gloves when operating the hydraulic couplers. • Allow the machine to cool before touching hydraulic components. • Do not touch hydraulic fluid spills. Filling a Trench 1. Start the machine. 2.
Operating Tips • Clean the area of trash, branches, and rocks before trench filling to prevent equipment damage. • For best trench filling, center the unit over the trench (Figure 5). g013188 Figure 5 • Always begin trench filling with the slowest ground speed possible. Increase the speed if conditions permit. • Always use full throttle (maximum engine speed) when trench filling. • Never transport the trench filler with the loader arms raised.
Maintenance Recommended Maintenance Schedule(s) Maintenance Service Interval Maintenance Procedure • Grease the auger bearing. Every 200 hours • Paint chipped surfaces. Before storage Yearly or before storage • Adjust the skids. CAUTION If you leave the key in the switch, someone could accidently start the engine and seriously injure you or other bystanders. Remove the key from the switch before you perform any maintenance.
Storage 1. Before long-term storage, wash the attachment with mild detergent and water to remove dirt and grime. 2. Check the condition of the teeth. Turn or replace any worn or damaged teeth. 3. Check and tighten all bolts, nuts, and screws. Repair or replace any damaged or worn part. 4. Ensure that all hydraulic couplers are connected together to prevent contamination of the hydraulic system. 5. Paint all scratched or bare metal surfaces. Paint is available from your Authorized Service Dealer.
Troubleshooting Problem The attachment does not operate. Possible Cause Corrective Action 1. A hydraulic coupler is not completely connected. 1. Check and tighten all couplers. 2. A hydraulic coupler is damaged. 2. Check the couplers and replace any that are damaged. 3. Find and remove the obstruction. 3. There is an obstruction in a hydraulic hose. 4. A hydraulic hose is kinked. 5. The auxiliary valve on the traction unit is not opening. 11 4. Replace the kinked hose. 5. Repair the valve.
Notes:
Notes:
Declaration of Incorporation Model No. 22472 Serial No. Product Description Invoice Description General Description Directive 404320000 and Up Trench Filler, Compact Utility Loader TRENCH FILLER ATTACHMENT CE Compact Utility Loader 2006/42/EC Relevant technical documentation has been compiled as required per Part B of Annex VII of 2006/42/EC. We will undertake to transmit, in response to requests by national authorities, relevant information on this partly completed machinery.
European Privacy Notice The Information Toro Collects Toro Warranty Company (Toro) respects your privacy. In order to process your warranty claim and contact you in the event of a product recall, we ask you to share certain personal information with us, either directly or through your local Toro company or dealer. The Toro warranty system is hosted on servers located within the United States where privacy law may not provide the same protection as applies in your country.
California Proposition 65 Warning Information What is this warning? You may see a product for sale that has a warning label like the following: WARNING: Cancer and Reproductive Harm—www.p65Warnings.ca.gov. What is Prop 65? Prop 65 applies to any company operating in California, selling products in California, or manufacturing products that may be sold in or brought into California.
