Form No. 3429-951 Rev C Grapple TXL 2000 Tool Carrier or Outcross 9060 Series Traction Unit Model No. 22535—Serial No. 318000001 and Up Register at www.Toro.com.
WARNING CALIFORNIA Proposition 65 Warning Use of this product may cause exposure to chemicals known to the State of California to cause cancer, birth defects, or other reproductive harm. g270249 Figure 1 Introduction 1. Model and serial number location This grapple is a load-bearing attachment intended to be used on a Toro tool carrier or multipurpose machine.
Contents Safety Safety ....................................................................... 3 General Safety ................................................... 3 Slope Safety ....................................................... 4 Grapple Safety ................................................... 4 Maintenance and Storage Safety........................ 4 Safety and Instructional Decals .......................... 5 Product Overview .....................................................
Slope Safety • Use caution when operating the machine near the following: • Operate the machine up and down slopes with – Drop-offs the heavy end of the machine uphill. Weight distribution changes with attachments. An empty load-bearing attachment makes the rear of the machine the heavy end, and a full load-bearing attachment makes the front of the machine the heavy end. Most other attachments make the front of machine the heavy end.
Safety and Instructional Decals Safety decals and instructions are easily visible to the operator and are located near any area of potential danger. Replace any decal that is damaged or missing. decal138-0544 138-0544 1. Entanglement hazard, grapple—keep hands away. decal125-6128 decal138-4188 125-6128 138-4188 1. High pressure fluid hazard, injection into the body—read the Operator’s Manual before performing maintenance. 1.
Operation Product Overview Determine the left and right sides of the machine from the normal operating position. Installing and Removing the Attachment Refer to the Operator’s Manual for the traction unit for the installation and removal procedure. Important: Before installing the attachment, position the machine on a level surface, ensure that the mount plates are free of any dirt or debris, and ensure that the pins rotate freely. If the pins do not rotate freely, grease them. g270260 Figure 3 1.
Digging/Raking with the Upper Jaw CAUTION Hydraulic couplers, hydraulic lines/valves, and hydraulic fluid may be hot. If you contact hot components, you may be burned. 1. To dig or rake using the upper jaw, open the jaws all the way, and tilt the attachment forward until the upper jaw teeth touch (or penetrate) the ground. 2. Drive the machine rearwards. To rake up loose sticks and other debris, which you can then grab with the jaws, place the teeth on the ground.
Digging with the Lower Jaw 1. To dig or rake using the lower jaw, open the jaws and lower the lower jaw teeth into the ground (Figure 6). 2. Drive the machine forward. Note: This digs furrows in the earth, breaking up the sod, and also pushes any debris ahead of the attachment. g270317 Figure 6 Transport Position When transporting the grapple, keep it as close to the ground as possible, no more than 15 cm (6 inches) above the ground, and keep the loader arms retracted. Tilt it rearward.
Maintenance Checking the Hydraulic Lines Determine the left and right sides of the machine from the normal operating position. Service Interval: Before each use or daily CAUTION WARNING If you leave the key in the switch, someone could accidently start the engine and seriously injure you or other bystanders. Hydraulic fluid escaping under pressure can penetrate skin and cause injury.
Storage 1. Before long-term storage, wash the attachment with mild detergent and water to remove dirt and grime. 2. Paint all scratched or bare metal surfaces. Note: Paint is available from your Authorized Service Dealer. 3. Store the attachment in a clean, dry garage or storage area. Cover it to protect it and keep it clean.
Notes:
California Proposition 65 Warning Information What is this warning? You may see a product for sale that has a warning label like the following: WARNING: Cancer and Reproductive Harm—www.p65Warnings.ca.gov. What is Prop 65? Prop 65 applies to any company operating in California, selling products in California, or manufacturing products that may be sold in or brought into California.
