Form No. 3426-139 Rev C Pick-Up Broom Water Kit TXL 2000 Tool Carrier Model No. 22545 Installation Instructions Safety Safety and Instructional Decals Safety decals and instructions are easily visible to the operator and are located near any area of potential danger. Replace any decal that is damaged or missing. decal138-0543 138-0543 1. Warning—read the Operator’s Manual; only use water. decal139-2835 139-2835 1.
Installation Loose Parts Use the chart below to verify that all parts have been shipped. Description Use Qty.
Installing the Water Kit 1. 3. Secure the tank with the 2 ratchet straps (Figure 3). Install the water tank assembly to the water tank mount using 6 bolts (5/16 x 3/4 inch) and flat washers (5/16 inch) as shown in Figure 1. Important: Do not overtighten the hardware; overtightening may cause damage to the tank. g269791 Figure 3 g269777 1. Ratchet straps Figure 1 1. Water tank assembly 3. Flat washer (5/16 inch) 2. Water tank mount 4. Bolt (5/16 x 3/4 inch) 2. 4.
5. Install the spray bar assembly to the spray bar mounting brackets with the carriage bolts (1/2 x 1-1/4 inches), flat washers (1/2 inch), and locknuts (1/2 inch) in the lowest hole on the spray bar mounting brackets (Figure 13). 10. Connect the opposite end of the long wire harness to the switch wire harness. 11. Route the switch wire harness and switch along the hydraulic lines, past the machine couplers, and to the control panel of the traction unit.
Installing the Gutter Brush Spray Nozzle (Optional) If the pick-up broom is equipped with a gutter brush, this kit includes a spray nozzle that can be mounted to it. 1. On the spray bar, cut the hose between the last 2 nozzles nearest the gutter brush and install the tee with hose clamps. g269815 Figure 9 g269813 Figure 8 1. Bolt 3. Spray nozzle mount 1. Tee 2. Gutter brush motor mount 4. Nut 2. 3.
Adjusting the Flow Rate Operation Adjust the flow rate to the desired setting using the knob on the pressure regulator. WARNING A full water tank can affect the stability of the machine, which may lead to a tip-over, causing serious injury or death. • Do not extend the attachment arms when operating the pick-up broom. • Do not raise the arms higher than necessary to dump the bucket. • Do not travel with the pick-up broom raised above the ground. Preparing to Operate g269753 1.
Maintenance Adjusting the Spray-Bar Height Unclogging the Nozzles As the pick-up broom bristles wear, the spray-bar height may need to be adjusted to ensure complete spray coverage. Refer to the following steps: 1. 2. Service Interval: Before each use or daily Turn on the spray pump and ensure that the spray pattern provides complete coverage to the area in front of the pick-up broom.
Cleaning the Strainer Storage Service Interval: Before each use or daily 1. Locate the tank strainer from the inside of the tank (Figure 15). 2. Clean any debris from the strainer screen. Storing the Machine g269730 Figure 15 1. Tank strainer 8 1. If the tank is not going to be used for an extended period of time, completely drain the tank, pump, and lines. 2.
