Form No. 3429-975 Rev B Standard Bucket, High-Volume Bucket, or Grading Bucket TXL 2000 Tool Carrier Model No. Model No. Model No. Model No. Register at www.Toro.com. Original Instructions (EN) 22546—Serial No. 22547—Serial No. 22548—Serial No. 22576—Serial No.
WARNING CALIFORNIA Proposition 65 Warning Use of this product may cause exposure to chemicals known to the State of California to cause cancer, birth defects, or other reproductive harm. g267815 Figure 2 High volume bucket Introduction 1. Model and serial number location The bucket is a load-bearing attachment intended to be used on a Toro tool carrier. It is designed primarily for moving rock, dirt, sand, or other materials.
Contents Safety Safety ....................................................................... 3 General Safety ................................................... 3 Slope Safety ....................................................... 4 Bucket Safety ..................................................... 4 Maintenance and Storage Safety........................ 4 Safety and Instructional Decals .......................... 5 Product Overview .....................................................
Slope Safety • Use caution when operating the machine near the following: • Operate the machine up and down slopes with – Drop-offs the heavy end of the machine uphill. Weight distribution changes with attachments. An empty load-bearing attachment makes the rear of the machine the heavy end, and a full load-bearing attachment makes the front of the machine the heavy end. Most other attachments make the front of machine the heavy end.
Safety and Instructional Decals Decal 139-2836 is for Model 22547. Safety decals and instructions are easily visible to the operator and are located near any area of potential danger. Replace any decal that is damaged or missing. decal139-2836 139-2836 1. Tipping hazard—read the TXL 2000 Operator’s Manual for load limits; the maximum load with the attachment retracted is 887 kg (1,956 lb); the maximum load with the attachment extended is 412 kg (909 lb). decal125-6110 125-6110 1.
Product Overview Decal 139-2838 is for Model 22548. Specifications Note: Specifications and design are subject to change without notice. Model 22546—High Volume Bucket decal139-2838 139-2838 1. Tipping hazard—read the TXL 2000 Operator’s Manual for load limits; the maximum load with the attachment retracted is 852 kg (1,880 lb); the maximum load with the attachment extended is 410 kg (905 lb).
Maximum Material Density at Capacity Material Density The density of the materials moved by the bucket varies and, therefore, so does the amount of material that the bucket can carry before reaching the maximum load rating. The first 2 tables lists the density of material that can be carried, both heaped and struck (i.e., leveled off), in the bucket. The Material Density table lists common materials and their densities.
Filling the Bucket Operation Determine the left and right sides of the machine from the normal operating position. Installing and Removing the Attachment Refer to the Operator’s Manual for the traction unit for the installation and removal procedure. 1. Position the bucket level to the ground. 2. Drive forward and insert the bucket into the pile of material. 3.
Transport Position Storage When transporting a load, keep the attachment as close to the ground as possible, no more than 15 cm (6 inches) above the lowest position. Tilt it rearward to keep the load level. 1. Before long-term storage, wash the attachment with mild detergent and water to remove dirt and grime. 2. Paint all scratched or bare metal surfaces. Note: Paint is available from your Authorized Service Dealer. 3. g240205 Figure 6 1. No more than 15 cm (6 inches) above the lowest position 2.
Notes:
Notes:
California Proposition 65 Warning Information What is this warning? You may see a product for sale that has a warning label like the following: WARNING: Cancer and Reproductive Harm—www.p65Warnings.ca.gov. What is Prop 65? Prop 65 applies to any company operating in California, selling products in California, or manufacturing products that may be sold in or brought into California.
