Form No. 3453-130 Rev A Adjustable Forks TXL 2000 Tool Carrier or Outcross® 9060 Series Traction Unit Model No. 22549—Serial No. 318000001 and Up Register at www.Toro.com.
WARNING CALIFORNIA Proposition 65 Warning Use of this product may cause exposure to chemicals known to the State of California to cause cancer, birth defects, or other reproductive harm. Introduction g267931 Figure 1 1. Model and serial number location The adjustable forks attachment is a load-bearing attachment intended to be used on a Toro tool carrier or multipurpose machine. It is designed primarily for moving material such as posts, rocks, trees, pallets, etc.
Contents Safety Safety ....................................................................... 3 General Safety ................................................... 3 Slope Safety ....................................................... 4 Forks Safety ....................................................... 4 Maintenance and Storage Safety........................ 4 Safety and Instructional Decals .......................... 5 Setup ........................................................................
Slope Safety • Use caution when operating the machine near the following: • Operate the machine up and down slopes with – Drop-offs the heavy end of the machine uphill. Weight distribution changes with attachments. An empty load-bearing attachment makes the rear of the machine the heavy end, and a full load-bearing attachment makes the front of the machine the heavy end. Most other attachments make the front of machine the heavy end.
Safety and Instructional Decals Safety decals and instructions are easily visible to the operator and are located near any area of potential danger. Replace any decal that is damaged or missing. decal125-6110 125-6110 1. Crushing hazard—do not stand under any part of the machine. decal133-8061 133-8061 decal138-4188 138-4188 1. Warning—read the Outcross 9060 Operator’s Manual for more information about the attachments. decal139-2841 139-2841 1.
Setup Product Overview Installing the Forks For each fork, hang the upper hook over the center of the frame, insert the bottom hook through the bottom notch as shown in Figure 3, then slide it to the desired location. g266929 Figure 4 1. Upper frame 3. Adjustable-forks frame 2. Fork g266927 Figure 3 Specifications Note: Specifications and design are subject to change without notice.
Operation Determine the left and right sides of the machine from the normal operating position. Installing and Removing the Attachment Refer to the Operator’s Manual for the traction unit for the installation and removal procedure. g272288 Important: Before installing the attachment, Figure 5 position the machine on a level surface, ensure that the mount plates are free of any dirt or debris, and ensure that the pins rotate freely. If the pins do not rotate freely, grease them. 1.
Operating Tips Storage • To adjust the forks, slide them along the frame to the desired width. Adjust the forks to the widest possible setting to ensure that the load is as stable as possible. 1. Before long-term storage, wash the attachment with mild detergent and water to remove dirt and grime. • When transporting a load, keep the attachment as 2. Check and tighten all bolts, nuts, and screws. Repair or replace any damaged or worn part. 3. Paint all scratched or bare metal surfaces.
Notes:
Notes:
Notes:
California Proposition 65 Warning Information What is this warning? You may see a product for sale that has a warning label like the following: WARNING: Cancer and Reproductive Harm—www.p65Warnings.ca.gov. What is Prop 65? Prop 65 applies to any company operating in California, selling products in California, or manufacturing products that may be sold in or brought into California.