Reference Guide

ManualsBrandsToro ManualsStump GrindersToro 22615HD

Revision 1 09-24-2021 Toro Form No 3450-200 Rev A

Tool Inspection Process

Check the operating hours on the hour meter, then perform the necessary maintenance procedures as specified in the following table (for complete

procedures, refer to the Operator’s Manual):

Maintenance Service Interval

Maintenance Procedure

After each use • Check for and replace any missing or damaged parts, especially safety devices, shields, guards, and decals;

ensure that the machine starts and operates properly.

• Tighten all fasteners.

• Check the engine oil level.

• Grease the machine.

• Check the air filter cyclone housing for a layer of dirt in the bottom of the container. Clean it if dirty.

• Check the drive belt tension.

• Remove debris from the machine.

• Check the condition of the teeth; rotate or replace any that are worn or damaged; torque the nuts for all teeth.

After the first 20 hours Change the engine oil.

Every 50 hours

Clean the air filter cyclone housing, air channels, and air intake screen.

Tool Rental Center

Tool Turn Guide

SGR-13 Stump Grinder

Model No. 22615HD—402000000 and Up

Supplier Technical Support #:

888-384-9939 (US and Canada)

Supplier Website: www.Toro.com

PURPOSE

Follow the directions below to maintain this tool.

SAFETY

Refer to the product Operator’s Manual for complete safety information.

Summary of content (5 pages)

PAGE 1
Tool Turn Guide Tool Rental Center SGR-13 Stump Grinder Model No. 22615HD—402000000 and Up Supplier Technical Support #: 888-384-9939 (US and Canada) Supplier Website: www.Toro.com PURPOSE Follow the directions below to maintain this tool. SAFETY Refer to the product Operator’s Manual for complete safety information.
PAGE 2
Maintenance Service Interval Maintenance Procedure Every 100 hours • Change the engine oil. • Clean the sediment cup. • Check the spark plugs. • Replace the drive belt. Every 200 hours Replace the air filter. Yearly or before storage • Change the engine oil. • Clean the sediment cup. Important: Refer to the Engine Operator's Manual for additional maintenance procedures. Tool Cleaning Process Regular cleaning and washing will increase the life span of the machine.
PAGE 3
Rotating or Replacing a Tooth Due to the high amount of wear placed on the teeth, you will need to rotate and replace them periodically (Figure 1). Before you rotate or replace them, inspect each tooth holder on the wheel, including the flat lands that prevent the teeth from rotating. If the tooth holder is damaged, replace the wheel. Torque the nuts 60 to 76 N∙m (44 to 56 ft-lb) for any teeth that you are not rotating or replacing.
PAGE 4
Spring Maintenance Tool Rental Center Guide Supplier Technical Support #: 800-888-9926 (US and Canada) SGR-13 Stump Grinder Supplier Website: www.Toro.com Model No. 22615HD—316000001 and Up PURPOSE Follow the directions below to maintain this tool. SAFETY Refer to the product Operator’s Manual for complete safety information.
PAGE 5
Recommended Parts Action Part Number Description Check operation of the operator presence switch and control. Check operation of the parking brake. Recommended Routine Maintenance: Recommended Parts Action Part Number Description Replace the air filter. Source from Honda Air filter Replace the spark plug. Source from Honda Spark plug Change the engine oil.