Reference Guide

Revision 1 02-24-2021 Toro Form No 3445-727 Rev A
Maintenance Service Interval Maintenance Procedure
Every 100 hours • Change the engine oil.
• Clean the sediment cup.
• Check the spark plugs.
• Replace the drive belt.
Every 200 hours
Replace the air filter.
Yearly or before storage • Change the engine oil.
• Clean the sediment cup.
Important: Refer to the Engine Operator's Manual for additional maintenance procedures.
Tool Cleaning Process
Regular cleaning and washing will increase the life span of the machine. Clean the machine after use, before the dirt hardens.
Check before cleaning that the fuel tank cap is properly in place to avoid getting water in the tank.
Use care when using a high-pressure washer because it can damage decals, grease seals, and the engine.
Important: Lubricate the cutting wheel blade bearings after cleaning.