Service Manual

3-14 FUEL SYSTEM
Intake Manifold
Intake Manifold Removal
•
Remove:
Air Cleaner (see Cleaner Body Removal)
Engine Upper Cover
Carburetor (see Carburetor Removal)
•
Remove the harness from the clamps [A] on the intake manifold.
•
Unscrew the manifold mounting bolts [B].
Intake Manifold Installation
•
Replace the O-rings [A] with new ones.
•
Clean the mating surfaces of the cylinders and intake manifolds.
•
Clean the mating surfaces of the carburetor and intake manifold and
install the new gaskets [A] and intake manifold.
•
Tighten the mounting bolts following the tightening sequence.
Torque - Intake Manifold Mounting Bolts: 6.9 N 1 m (0.70 kgf 1 m, 61 in 1 lb)
•
Fasten the harness [A] into the clamps [B] on the intake manifold [C].

Position the harness on top of the manifold as shown.
•
Install the other removed parts.