Service Manual

8-10 ELECTRICAL SYSTEM
Charging, Ignition System
•
Remove:
Woodruff Key [A]
Stator Coil Lead Connector [B]
Stator Coil Screw [C]
Stator Coil [D]
Flywheel, Stator Coil Installation
•
Install the stator coil and tighten the screws.
Torque - Stator Coil Screws: 3.4 N 1 m (0.35 kgf
1 m, 30 in
1 lb)
•
Using a cleaning fluid, clean off any oil or dirt on the following portions
and dry them with a clean cloth.
[A] Crankshaft Tapered Portion
[B] Flywheel Tapered Portion
•
Fit the Woodruff key [C] securely in the slot in the crankshaft before
installing the flywheel.
•
Install the flywheel onto the crankshaft taper so that the woodruff key
fits in the key way in the hub of the flywheel.
•
Install the fan [A] so that two positioning bosses [B] fit around flywheel
ignition magnet [C].
•
Install the plate [D] so that the notch [E] inserts into the slot in the
flywheel.
•
Install the screen [A] so that the projections [B] fit into the recess [C]
of the fan (Recoil starter model).
•
Install the pulley or bracket [A] so that the tabs of the plate fit into
holes [B].
•
Put the washer [C] as shown.
•
Tighten the flywheel bolt [D].
Torque - Flywheel Bolt: 56 N 1 m (5.7 kgf 1 m, 41 ft 1 lb)