Service Manual

ELECTRICAL SYSTEM 8-15
Charging, Ignition System
Ignition Coil Removal
•
Remove:
Fan Housing (see Flywheel, Stator Coil Removal)
Spark Plug Cap [A]
Stop Switch Lead Connector [B]
Bolts [C]
Ignition Coil [D]
Ignition Coil Installation
•
Install ignition coil on crankcase so that the stop switch lead connector
[B] face the screen, and tighten bolt (1) first, then tighten bolt (2).
While tightening bolts, adjust the air gap [A] between the three legs
of ignition coil and the two pole-plates of magnet to the specified gap
value as shown.
Ignition Coil Air Gap
Standard: 0.2
0.4 mm (0.008 0.016 in.)
Torque - Ignition Coil Bolts (Stud Bolt)
7.8 N
1 m (0.80 kgf
1 m, 69 in
1 lb)
Ignition Coil Bolts (Flanged Bolt)
5.9 N
1 m (0.60 kgf 1 m, 52 in
1 lb)
NOTE

Above procedure must be used to insure proper coil air gap is not
too large.