Service Manual
FUEL SYSTEM 3-5
Governor Link Mechanism
Control Panel Assembly Removal
•
Remove:
Air Cleaner (see Cleaner Body Removal)
Control Panel Mounting Bolts [A]
•
Remove the control panel assembly [A] while unhooking the governor
spring [B] end loop at the panel bracket.
•
Clear the choke link rod lower end [C] from the choke lever.
Control Panel Assembly Installation
•
Before installing the control panel assembly, check to see that the
choke lever [A] and engine speed control lever [B] move smoothly in
all directions.
If any part is worn or damaged, replace the control panel assembly.
•
After installation, adjust the low idle speeds and high idle speeds to
the specifications (see Periodic Maintenance chapter).
Governor Arm Removal
•
Remove:
Control Panel Assembly
•
Loosen the clamp nut [A] and take off the governor arm [B].
•
Unhook the throttle link rod spring [C] end loop and clear the throttle
link rod lower end [D].