Service Manual
FUEL SYSTEM 3-7
Governor Link Mechanism
Governor Assembly Inspection
Visually check all governor parts for wear and damage.
If any parts are worn or damaged, replace them.
Governor Shaft Removal
•
Split the crankcase (see Camshaft/Crankcase chapter).
•
Unscrew the governor shaft plate screws [A], and pull out the governor
shaft [B] outside.
NOTE
It is not necessary to remove the governor shaft unless it is being
replaced.
•
Replace the oil seal only if the lip shows signs of leakage or it has
been damaged.
•
The oil seal [A] must be assembled with seal lip towards inside of the
engine.
•
Press in the oil seal 0
1.0 mm (0.04 in.) [B] flush or below the
crankcase surface [C].
Governor Shaft Installation
•
Apply engine oil to the governor shaft.
•
Insert the governor shaft into the crankcase.
•
Install the governor shaft plate [A] to the shaft [B] as shown.
Torque - Governor Shaft Plate Screws: 2.0 N
1
m (0.20 kgf
1
m, 18 in
1
lb)
•
Check that the governor shaft moves freely in its operating range.
NOTE
If the oil seal is removed, oil seal is put on after shaft is installed.