Service Manual

8-10 STARTER SYSTEM
Electric Starter System
•
Install the pinion clutch [A].
•
Install the rear stopper [B] so that the hollow side face the
outside.
•
Install the snap ring [C] to the groove of the shaft.
•
Slide the rear stopper until the stopping with the snap ring.
•
Install the front stopper [D] so that the smaller diameter
face the inside.
•
Apply grease to the pinion gear fork fingers.
•
Assemble the pinion gear fork [E] as shown in the figure.
•
Install the armature assembly [A] to the pinion gear cover
[B].
•
Install the yoke so that the slit [A] fit the projection [B] of
the pinion gear fork.
•
Install the brush holder [A].
•
Install the brushes [B] to the brush holder.
•
Install the springs [A].