Service Manual
3-24 FUEL SYSTEM
Carburetor
•
Install the throttle link rod [A] and spring [B] to the throttle
shaft lever clip [C].
NOTE
○
Take care not to bend the throttle link rod during instal-
lation.
•
Make sure the link spring around the throttle link rod is
in place and that it pulls the governor arm and carburetor
throttle shaft lever toward each other.
FX Models [D]
FR and FS Models [E]
•
Install the fuel tube [A] fully so that the clamp knob [B]
faces the downward.
•
Apply dielectric grease to the solenoid valve terminal.
•
Connect the solenoid valve connector.
•
Install the removed parts (see approp
riate chapters).
•
After installation, adjust the idle speed (see Low/High Idle
Speed Adjustment in the Periodic Maintenance chapter).
FX Models [C]
FR and FS Models [D]