Service Manual
ENGINE TOP END 5-9
Cylinder Head
•
Set each piston at the T.D.C [A] of the compression
stroke.
•
Put new gaskets and the cylinder head assemblies on
each cylinder.
NOTE
○
As the head gaskets are coated with sealing agents, be
careful not to damage the surfaces.
•
Tighten the cylinder head bolts following the tightening
sequence as shown in the figure.
Torque - Cylinder Head Bolts: 46 N·m (4.7 kgf·m, 34 ft·lb)
CAUTION
A torque wrench must be used to assure proper
torque. Improper tightening of the head bolts may
result in warping of the cylinder head.
•
Install:
Rocker Arm Bracket (see Valve Mechanism Removal/In-
stallation)
Push Rod (see Push Rod Installation)
Rocker Arm (see Valve Mechanism Removal/Installa-
tion)
•
Install the new gaskets and rocker covers.
•
Tighten the rocker cover bolts following the tightening se-
quence as shown in the figure.
Torque - Rocker Cover Bolts: 5.9 N·m (0.60 kgf·m, 52 in·lb)
•
Install the removed parts (see appropriate chapters).
Push Rod Removal
•
Set each piston at the T.D.C of the compression stroke.
•
Remove the rocker arm (see Valve Mechanism Re-
moval/Installation).
•
Pull out the push rods [A]
NOTE
○
Mark the push rods and rocker arms so they can be
installed in their original position during assembly.