Installation Instructions

THIS KIT FITS TORO 2300 TOPDRESSER

SERIAL NUMBERS 30381 AND ABOVE.

1. Remove the two bolts that attach the existing

valve to the frame. Leave all hydraulic lines

attached to the valve and allow the valve assembly

to drop downward.

2. Release the air pressure from the tank.

3. Remove the plug from the valve as shown in Fig.

1. Screw in the electric solonoid with cartridge.

Secure.

4. Secure the valve to the frame as it was before.

5. Plug the wire harness (01-606-0420) for the

on/off switch into the back of the valve on the

solenoid. Attach the valve to the frame using the

existing 5/16" x 1" bolts. Secure tightly.

6. Make sure all fittings and hydraulic hoses are

tight. If necessary, rotate the fittings to eliminate

any binding of the hoses.

The TORO Company - 1993

FORM NO. 01-502-1440

INSTALLATION

INSTRUCTIONS

PART NO. 23-008-0081

2300 BRAKE KIT

(for WORKMAN 3000)

FILTER

Plug

Figure 1

PAGE 1
FORM NO. 01-502-1440 INSTALLATION INSTRUCTIONS PART NO. 23-008-0081 2300 BRAKE KIT (for WORKMAN  3000) 4. Secure the valve to the frame as it was before. THIS KIT FITS TORO 2300 TOPDRESSER SERIAL NUMBERS 30381 AND ABOVE. 1. Remove the two bolts that attach the existing valve to the frame. Leave all hydraulic lines attached to the valve and allow the valve assembly to drop downward. 5. Plug the wire harness (01-606-0420) for the on/off switch into the back of the valve on the solenoid.
PAGE 2
INSTALLATION INSTRUCTIONS (Continued) 9. Plug the wire harness (01-606-0410) into the harness as shown in Fig. 2. Plug the other end into the wire harness(01-606-0420) previously installed, that connects to the valve. 7. Route the wire harness (01-606-0420) through the tongue on the Topdresser towards the rear of the Workman. 8. On the left hand side of the Workman, separate the harness going into the taillights as shown in Fig. 2.