Installation Instructions

1. Remove support rods, hopper back, hopper
brace, gate and gate rods from the topdresser.
2. Drill (2) 17/32" diameter holes 1-1/2" above
existing holes.
3. Trim 1-1/2" off bottom of hopper back.
4. Replace hopper back, new support and new
hopper brace using existing hardware.
5. Remove adjustment lugs and hardware from
the old gate and reinstall on the new gate.
6. Drill out the pop rivets to remove the gate seal
from the old gate.
7. Pop rivet the gate seal and new slides to the
new gate.
8. Install new gate on the topdresser.
9. Replace old gate rods with new gate rods using
existing hardware.
Figure 1
Part No. Description Qty.
23-004-1021 Gate Rod 2
23-004-0991 Gate 1
23-005-1101 Support Rod 2
23-004-1031 Hopper Brace 1
23-004-1041 Slide 2
©
The TORO Company - 1991
FORM NO. 01-502-1660
INSTALLATION
INSTRUCTIONS
PART NO. 23-008-0091
SAND FLOW KIT
(FOR TOPDRESSER 2300)