TOR ruse 2 CYCLE ENGINE: Larson V-22 FUEL TANK CAPACITY: quart CUTTER BLADE: long. Hardened high carbon steel, attached with slip clutch, WHEELS: #18 Ga. Steel discs w/oil impregnated TIRES: Front-semi-pneumatic, Chevron tread. Rear-Semi-pneumatic, Chevron tread. HEIGHT OF CUT: moving wheels. HOUSING: Permanent molded aluminum alloy, front right hand discharge. HANDLE: 3/4" 0.D. x #18 Ga, welded steel tubing in separable halves. Plastic ting grips.
Unpack your Tore Rotary Mower and put it down on a smooth, level, working surface. Be sure you have removed all the parts from the shipping carton before you discard it; inspect everything carefully for possible damage in transit. Figure 1 Figure 2 The handle is shipped in two sections. Join these set hen install the handle quadrant in the handle bracket cutely together, (Fig. 1} with the bolts and nuts canon the main frame as illustrated in Figure 2. Slotted rained in the envelope.
Your Tore Rotary Mower is equipped with a heat treated cutter bar made of fine, tough steel. Most of the mowing is done by the outer sharpened ends. Remember that the sharper these ends are the better and easier the cutting will be, IMPORTANT: Use only GENUINE TOR CUTTER BARS for perfect balance and safety. Substitute cutter bars not designed for this mower may be dangerous.
e A SRR Read the engine instruction manual for directions about putting oil in the engine and air cleaner and for setting choke and throttle for starting. The rotary blade will cut grass whether the mower is being pushed forward or pulled back. Remember that the engine can be shut off instantly by pushing the stop switch against the top of the spark plug to short it. Now start the engine and let it warm up for a minute or two.
Ref. No. Ref. No. No. | Part No. Description Used No. | Part No. Description Used 1 | 2-1308 Housing 1 32 | WK-380 [Bearer Wheel Says, Includes | 2 2 3210-8 Screw, 1/2% 3 2-Ref. 28 Bushings 3 | 3966-23 Washer, 234-13 Tire, Rear 8" 2 4 3253-4 Lock washer, 5/16” Reg. 3 34 | WK-375 [6"Front Wheel Says. ,Includes) 2 5 | 3296-30 Nut, 5/16" N.F.
12" DRILL PRESS POWER TOOLS For mun years, locus service on a national basis has been the chief objective of the Toto organization. The local Toto Distributor can provide efficient and prompt service backed by genuine Toto repair parts. Protect and insure the long efficient life built inch & Toto product by using only genuine Toto parts—engineered fo fit and wear exactly like the original part.