Installation Instructions

ManualsBrandsToro ManualsCompact LoaderToro 23162

Form No. 3358-367 Rev A

Backhoe Mounting Kit

For TX Compact Utility Loaders

Model No. 23162

Installation Instructions

Important: T his document contains the inf or mation f or installing and connecting the

backhoe to a TX series compact utility loader . R efer to the Backhoe Operator’ s Man ual f or

safety , operation, and maintenance inf or mation.

Loose Parts

Use the chart below to verify that all parts have been shipped.

Step

Description

Qty.

Use

Lanyard/Hydraulics Lever Clamp

Screw

Washer

Locknut

Holding pin

Install the lanyard to the seat.

Change the tilt cylinder pin.

Link

Lynch pin

Connect the backhoe to the traction

unit.

Hydraulics lever clamp

Prepare the backhoe for operation.

Step

Installing the Lanyard to the

Seat

Parts needed for this step:

Lanyard/Hydraulics Lever Clamp

Screw

Washer

Locknut

Holding pin

Procedure

1. Tilt the seat forw ard, loosen the seat knobs

and slide the seat forw ard.

2. Install the holding pin onto the lanyard.

3. Install the lanyard, attac hed to the h y draulics

lev er clamp , to the seat base with a screw ,

w asher , and loc kn ut ( Figure 1 ).

Figure 1

1. Locknut

4. Screw

2. Washer 5. Seat knobs

3. Lanyard attached to the

hydraulics lever clamp

6. Holding pin

8111 Lyndale Avenue South

Bloomington, MN 55420

Printed in the USA.

Summary of content (4 pages)

PAGE 1
Backhoe Mounting Kit Form No. 3358-367 Rev A For TX Compact Utility Loaders Model No. 23162 Installation Instructions Important: This document contains the information for installing and connecting the backhoe to a TX series compact utility loader. Refer to the Backhoe Operator’s Manual for safety, operation, and maintenance information. Loose Parts Use the chart below to verify that all parts have been shipped. Step 1 2 3 4 Use Qty.
PAGE 2
Step 4. Install the new pin into position and secure it with the bolt and nut removed previously, using the middle hole on the pin (Figure 2). 2 5. Grease the pin using the ﬁtting on the tilt cylinder. Changing the Tilt Cylinder Pin Note: Leave the new pin installed, even when the backhoe is removed. Step Parts needed for this step: 1 3 Pin Procedure Linking the Backhoe to the Traction Unit 1. Block up the mount plate so that it cannot swing forward.
PAGE 3
You could pinch and/or crush your hand when tilting the backhoe. Keep away from the moving backhoe when tilting. 4. Slide a link on one end of the tilt cylinder pin and the backhoe link pin and secure it with two lynch pins (Figure 3). Figure 5 Note: You may need to move the attachment tilt lever to line up the holes in the links with the pins. 5. Repeat step 4 for the other side. 1. Hydraulics lever clamp 4. 2. 3. Auxiliary hydraulics lever Reference bar 5.
PAGE 4
2. Remove the lynch pins securing the links and remove the links (Figure 3). Note: You may need to adjust the tilt lever slightly to loosen the links. 3. Secure the links and two lynch pins for storage on the pins on the backhoe and the other two lynch pins on the traction unit tilt cylinder pin. 4. Continue disconnecting the backhoe as described in the backhoe and traction unit Operator’s Manuals. Storage Storing the Hydraulics Lever Clamp Figure 7 1. Auxiliary hydraulics lever 2.