Service Manual

7-6 CAMSHAFT/CRANKSHAFT
Crankcase
Crankcase Cover Removal
•
Set the engine on a clean surface while parts are being
removed.
•
Drain the engine oil (see Engine Oil Change in the Peri-
odic Maintenance chapter).
•
Remove:
Oil Filter (see Oil Filter Replacement in the Periodic
Maintenance chapter)
Inlet Manifold (see Inlet Manifold Removal in the Fuel
System chapter)
Ignition Coils (see Ignition Coil Removal in the Electrical
System chapter)
Flywheel and Stator Coil (see Flywheel and Stator Coil
Removal in the Electrical System chapter)
Starter Motor (see Starter Motor Removal in the Starter
System chapter)
Governor Arm (see Governor Arm Removal in the Fuel
System chapter)
•
Unscrew the mounting bolts in the order shown [1 to 10]
and remove the crankcase cover [A] from the crankcase.
○
There are two dowel pins on the crankcase mating
surface. Using a wooden or plastic mallet, gently tap
crankcase to loosen the crankcase cover.
Crankcase Cover Disassembly
•
Remove:
Crankcase Cover (see Crankcase Cover Removal)
Governor Shaft (see Governor Shaft Removal in the Fuel
System chapter)
•
Pry the governor shaft oil seal [A] with the suitable tool,
and remove it.
•
Pry the crankshaft oil seal [A] with the suitable tool, and
remove it.