Service Manual

ELECTRICAL SYSTEM 9-13
Charging System
•
Install the fan [A].
•
Install the plate [B] so that the slits [C] fit to the bosses [D]
on the fan.
•
Tighten:
Torque - Cooling Fan Plate Mounting Bolts: 8.8 N·m (0.90
kgf·m, 78 in·lb)
FX Models
•
Attach the stator coil lead [A], ignition coil lead [B] and
solenoid valve connector lead [C] to the engine shroud
clamp [D] as shown in the figure.
FR and FS Models
•
Attach the stator coil lead [A], ignition coil lead and sole-
noid valve connector lead to the engine shroud with the
band [B].
FR Models [C]
FS Models [D]
FX Models
•
Install the fan housing.
•
Tighten:
Torque - Fan Housing Bolts: 5.9 N·m (0.60 kgf·m, 52 in·lb)
•
Install the screen.
•
Tighten:
Torque - Cooling Fan Screen Bolts: 5.9 N·m (0.60 kgf·m, 52
in·lb)
•
Install the guard.
Torque - Guard Mounting Bolts: 5.9 N·m (0.60 kgf·m, 52
in·lb)