Service Manual

3-12 FUEL SYSTEM
Governor Link Mechanism
•
Remove the bolt [A] to separate the governor arms [B].
Governor Arm Installation
•
Install the inside governor arm [A] onto the governor shaft
[B].
•
Be sure the link spring [C] around the throttle link rod [D]
is in place and that it pulls the outside governor arm [E]
and throttle lever [F] each other.
•
Tighten:
Torque - Governor Arm Clamp Nut [G]: 7.8 N·m (0.80 kgf·m,
69 in·lb)
•
Turn the top end of the governor arm countercl
ockwise to
fully open the carburetor throttle valve and hold it there.
•
Turn the inside governor arm counterclockwise fully to the
end of its travel.
•
Tighten:
Torque - Governor Arm Joint Bolt [H]: 5.9 N·m (0.60 kgf·m,
52 in·lb)
○
Governor arm joint bolt is left-hand threads.
•
Install the control panel assembly (see Control Panel As-
sembly Installation).
Governor Assembl
y Removal
•
Remove:
Camshaft (see Camshaft, Tappet Removal in the
Camshaft/Crank
shaft chapter)
Pin [A]
Washer (
30) [B]
Snap Rings [C]
Washer (
42) [D]
Sleeve [E]
Governor Plate [F]
Steel Balls [G]
Ball Guide [H]
Ball Plate [I]