Service Manual
9-16 ELECTRICAL SYSTEM
Charging System
Regulator Installation
FX Models
•
Install the regulator [A].
•
Tighten the regulator mounting screws [B].
•
Apply dielectric grease to the regulator terminals [C].
•
Connect the stator coil lead connector [D].
FS Models
•
Install:
Regulator [A]
Ground Lead [B]
•
Tighten the regulator mounting screws [C].
•
Apply dielectric grease to the regulator terminals [D].
•
Connect the stator coil lead connector [E].
Regulator Resistance
FS and FX Models
•
Remove the regulator (see Regulator Removal).
•
Set the KAWASAKI Hand Tester selector switch to the R
× 100 Ω position.
•
Connect the test leads to the points shown on the chart
and read the resistance.
(Without Charging Monitor Type …3 Blades)
+
–
A B C D
A
– ∞ ∞ ∞
B
∞ –
0
∞
C
∞ 0 – ∞
D
over than
1MΩ
over than
1MΩ
over than
1MΩ
–
NOTE
○
Resistance value may vary with individual meters.
If the resistance is not as specified, replace the regulator
with a new one.