Service Manual

LUBRICATION SYSTEM 6-11
Oil Screen
Oil Screen Removal
•
Remove the oil pump cover plate (see Oil Pump, Relief
Valve Removal).
•
Remove the oil screen [A].
Oil Screen Installation
•
Clean the oil screen thoroughly whenever it is removed
for any reason (see Cleaning and Inspection).
•
Insert the oil screen [A] in position.
•
Install the oil pump cover plate (see Oil Pump, Relief
Valve Installation).
Cleaning and Inspection
•
Clean the oil screen [A] with high-flash point solvent and
remove any particles stuck to it.
WARNING
Clean the screen in a well ventilated area, and take
care that there is no spark or flame anywhere near
the working area. Because of the danger of highly
flammable liquids, do not use gasoline or low-flash
point solvents.
NOTE
○
While cleaning the screen, check for any metal particles
that might indicate internal engine damage.
•
Check the screen carefully for a
ny damage: holes and
broken wire.
If the screen is damaged, replace it with a new one.