Service Manual

STARTER SYSTEM 8-5
Electric Starter System
Starter Motor Removal
•
Disconnect the wire.
•
Remove the mounting bolts [A] and pull the starter motor
[B] from the engine with the switch lead attached.
FX Models [C]
FR and FS Models [D]
Starter Motor Installation
•
Clean the starter motor and engine mounting flanges to
ensure good electrical contact and tighten the mounting
bolts.
○
Install the hook [A] so that the stopper [B] of the hook
contacts the crankcase.
Torque - Starter Motor Mounting Bolts: 19.6 N·m (2.00
kgf·m, 14.4 ft·lb)
Starter Solenoid and Circui
tTest
NOTE
○
Before this test, be sure the battery is fully charged.
•
Disconnect the starter motor lead [A] from the solenoid
terminal as shown and keep the lead away from the sole-
noid terminal.