Service Manual

9-18 ELECTRICAL SYSTEM
Ignition System
Ignition Coil Removal
•
Remove:
Fan Housing (see Flywheel and Stator Coil Removal)
Spark Plug Cap [A]
Bolts [B]
Stop Switch Lead Connector [C]
Ignition Coil [D]
Ignition Coil Installation
•
Install the ignition coil on the crankcase so that the stop
switch lead connector [A] face the upward, and tighten
bolt [B] first, then tighten bolt [C]. While tightening bolts,
adjust the air gap [D] between the legs of ignition coil and
the two pole-plates of magnet to the specified gap value
as shown in the figure.
Ignition Coil Air Gap
Standard: 0.2 ∼ 0.4 mm (0.008 ∼ 0.016 in.)
Torque - Ignition Coil Bolts: 5.9 N·m (0.60 kgf·m, 52 in·lb)
NOTE
○
Use the above procedure to insure proper coil air gap.
•
Fit the ignition coil leads [A] to the each engine shroud
groove [B].
•
Install the spark plug cap [C].