Service Manual

3-10 FUEL SYSTEM
Governor Link Mechanism
Control Panel Assembly Removal
FX Models
•
Remove:
Inlet Pipe Mounting Bolt [A] and Nut [B]
Control Panel Mounting Bolt [C]
Choke Spring [D]
Control Panel Assembly [E]
Governor Spring [F]
FR and FS Models
•
Remove:
Control Panel and Inlet Pipe Mounting Bolt [A]
Carburetor and Inlet Pipe Mounting Nut [B]
Control Panel Mounting Bolt [C]
Choke Spring [D]
Control Panel Assembly [E]
Governor Spring [F]
Control Panel Assembly Installation
•
Before installing the contr
ol panel assembly, check to see
that the choke lever [A] and engine speed control lever [B]
move smoothly in all directions.
If any part is worn or dama
ged, replace the control panel
assembly with a new one.
FX Models [C]
FR and FS Models [D]
FX Models
•
Install the governor spring [A], control panel assembly [B]
and choke spring [C].
•
Tighten:
Torque - Control Panel Mounting Bolt [D]: 5.9 N·m (0.60
kgf·m, 52 in·lb)
Carburetor and Inlet Pipe Mounting Nut [E]: 5.9
N·m (0.60 kgf·m, 52 in·lb)
Carburetor and Inlet Pipe Mounting Bolt [F]: 5.9
N·m (0.60 kgf·m, 52 in·lb)
•
After installation, adjust the low idle speed and high idle
speed to the specifications (see Low/High Idle Speed Ad-
justment in the Periodic Maintenance chapter).