Service Manual

FUEL SYSTEM 3-11
Governor Link Mechanism
FR and FS Models
•
Install the governor spring [A], control panel assembly [B]
and choke spring [C].
•
Tighten:
Torque - Control Panel Mounting Bolt [D]: 5.9 N·m (0.60
kgf·m, 52 in·lb)
Carburetor and Inlet Pipe Mounting Nut [E]: 5.9
N·m (0.60 kgf·m, 52 in·lb)
Control Panel and Inlet Pipe Mounting Bolt [F]: 5.9
N·m (0.60 kgf·m, 52 in·lb)
•
After installation, adjust the low idle speed and high idle
speed to the specifications (see Low/High Idle Speed Ad-
justment in the Periodic Maintenance chapter).
Governor Arm Removal
•
Remove the control panel assembly (see Control Panel
Assembly Removal)
•
Unhook the throttle link rod spring [A] end loop and clear
the throttle link rod lower end [B].
FX Models [C]
FR and FS Models [D]
•
Loosen the clamp nut [A] and take off the governor arm
[B].