Service Manual

3-20 FUEL SYSTEM
Carburetor
Inlet Pipe Removal
FX Models
•
Remove:
Air Cleaner (see Air Cleaner Body and Bracket Removal)
Control Panel Assembly (see Control Panel Assembly
Removal)
Inlet Pipe Mounting Bolt [A] and Nut [B]
Ground Lead [C]
Clamp [D]
Breather Hose [E]
Inlet Pipe [F]
FR and FS Models
•
Remove:
Element Assembly (see Element Removal)
Control Panel Assembly (see Control Panel Assembly
Removal)
Inlet Pipe Mounting Nut [A]
Ground Lead [B]
Clamp [C]
Breather Hose [D]
Inlet Pipe [E]
Inlet Pipe Installation
FX Models
•
Replace the gasket [A] with a new one.
•
Install:
Gasket
Inlet Pipe [B]
Ground Lead [C]
○
The side tongue [D] of the gasket faces #1 cylinder and
PTO side as shown.
•
Tighten:
Torque - Carburetor and Inlet Pipe Mounting Bolt [E]: 5.9
N·m (0.60 kgf·m, 52 in·lb)
Carburetor and Inlet Pipe Mounting Nut [F]: 5.9
N·m (0.60 kgf·m, 52 in·lb)
FR and FS Models
•
Replace the gasket [A] with a new one.
•
Install:
Gasket
Inlet Pipe [B]
Ground Lead [C]
•
Tighten:
Torque - Carburetor and Inlet Pipe Mounting Nut [D]: 5.9
N·m (0.60 kgf·m, 52 in·lb)