Service Manual

FUEL SYSTEM 3-25
Carburetor
Carburetor Disassembly/Assembly
FX Models
•
Refer to the illustration shown for disassembly and as-
sembly.
•
There are several passage plugs (ball plugs) in the car-
buretor body. Do not remove.
•
Before disassembly, mark the out side of choke and throt-
tle valves for assembling them.
•
Install the choke valve and throttle valve on the shaft as
the out side mark of them facing out side.
•
Drive the float pin into the carburetor body.
•
Assemble carburetor parts with recommended tightening
torque (see Exploded View).
1. Pilot Screw Plugs
2. Pilot Screws
3. Screw
4. Cover Plate
5. Pilot Jet Holder
6. O-ring
7. Screws
8. Choke Valve
9. Choke Shaft
10. Collar
11. Seal
12. Collar
13. Screws
14. Throttle Valves
15. Throttle Shaft
16. Throttle Shaft Holder
17. Seal
18. Main Jet (L)
19. Main Jet (R)
20. O-rings
21. Gasket
22. O-ring
23. Spacer
24. Pin
25. Float Valve
26. Float
27. O-ring
28. Gasket
29. Float Chamber
30. Screws
31. Solenoid Valve
32. Gasket
33. Drain Screw
34. Spring
35. Screw