Service Manual

FUEL SYSTEM 3-31
Inlet Manifold
Inlet Manifold Removal
•
Remove the engine shroud (see Engine Shroud Removal
in the Cooling System chapter)
•
Unscrew the inlet manifold mounting bolts [A].
•
Remove the inlet manifold [B] and gaskets.
FX Models [C]
FR and FS Models [D]
Inlet Manifold Installation
•
Replace the inlet manifold gaskets [A] with new ones.
•
Clean the mating surfaces of the cylinders and Inlet man-
ifolds.
•
Install the inlet manifold gaskets so that the hole [B] of the
gaskets fit the projection [C] of the cylinder head.
•
Install the inlet manifold.
•
Tighten the inlet manifold m
ounting bolts following the
tightening sequence.
Torque - Inlet Manifold Mounting Bolts: 5.9 N·m (0.60
kgf·m, 52 in·lb)
FX Models [A]
FR and FS Models [B]
•
Install the removed parts (see appropriate chapters).