72 74e TOR Tuner This Owner Manual has been especially prepared for your information and misguidance operation and care of your new Toto 20" §. P, Properly operated and maintained, this Toto 20" S, P, will respond quickly and easily to every reasonable demand and give years of reliable service. Toto 20" 8.P. mowers are manufactured by an organization of mowing machinery specialists. F Each machine is carefully inspected and tested before leaving the factory. For best performance from your Toto 20" 8, P.
Lubrication (Chart 1. WHEELS: The wheels are packed with grease at the factory and should require no further care. If wheels should become noisy a few drops of lubricating oil on the inner and outer bearings will suffice. 2. AIR CLEANER: Fill to level mark using S, A.E. 20 motor oil. Change every 2% operating hours, more often under dusty conditions. 3. ENGINE: Use good grade 20 motor oil. Change every 25 operating hours, more often under dusty conditions. 4.
Operating ATTACHING THE HANDLE Fig. 1 The handle is shipped in two halves, an upper half (A} (see Figure 1) and a lower half (B). Before mounting handle to the mower, join the halves securely with the bolt (C} and the nut (D} found in the envelope. Next install the handle quadrants (E) in the mower frame and fasten with the clevis pin (F) and hairpin cotter Then mount the handier in position loosely with the handle quadrants (E) on the outside.
Operating Instructions push traction lever down from slot and pull backwards. Figure 3 shows traction lever in proper position for forward meson. Throttle control (B) is shown in Figure 3 in the open position. Move in direction of arrow to close. MOWING SUGGESTIONS A little practice with the mower will soon show you the best way to use it to obtain the most efficient results.
Service Constructions ADJUSTMENTS TRACTION DRIVE When the traction drive rollers (A) (see Figure 5), become worn or loose on tires, make the following adjustments: If the drive rollers do not engage properly because the tire shave worn smooth, we recommend before making any adjustments that you try changing the front tires on the corresponding side and move them to the rear.
PARTS LIST Ref. No. Ref. No. No.| Part No. Description Used| No. | Part No. Description Used 1 2-1300 Housing 1 50 |2-1410 Nipple, Muffler 1 2 [3210-14 |Screw, 5/16" N.F.x 3 1/4" 3 51 12-1340 Name Plate Decal 1 3 |3256-23 | Washer, 5/16" |2-1850 Chute Decal i 4 | 2-1780 Spacer 3 53 12-1230 Wheel Bracket 2 5 3206-30 Nut, 5/18" N.F, 3 §4 13255-13 Sherlock, 7/16" External-1970 | Engine Support 1 Cask, 7 [2~1800 Blade Hub 1 58 |3289-9 Resew, T/18" 14 x 7/8" 4 8 |3267-3 Key 1 56 |3266-25 | Washer, 7/16" 8.A. E.