Operator's Manual

Hydrostatic-DriveBypassLever
Thehydrostatic-drivebypasslever(Figure8)releases
thehydrostatic-drivesystemsothatyoucanmovethe
machinebyhandwithouttheenginerunning.
Fornormaloperatingposition,pulluponthehandle
andthenpushitinuntilall3notchesareinsidethe
frame.
Note:Thelastnotchonthehandledoesnotlatch
ontheslot.
Toreleasethedrivewheels,pulluponthehandleand
pullitoutuntilthelastnotchengagesintheslot.Then
pushthehandledown.
g021333
Figure8
1.Handlein—normaloperatingposition
2.Allnotchesinsideframe
3.Handleout—hydrostatic-driverelease
4.Lastnotchengagedinslot
Specications
Note:Specicationsanddesignaresubjectto
changewithoutnotice.
Width
76cm(30inches)
Length(operating)137cm(54inches)
Length(withhandlestored)95.25cm(37.5inches)
Height(operating)113cm(44.5inches)
Height(withhandlestored)73.5cm(29inches)
Weight
120.2kg(265lb)
TorqueRequirements
BoltLocationTorque
Enginemountingbolts
37to45N⋅m(27to33ft-lb)
Clutchmountingbolts66to83N⋅m(49to61ft-lb)
Slicershaftnut88to115N⋅m(65to85ft-lb)
Attachments/Accessories
AselectionofToroapprovedattachmentsand
accessoriesisavailableforusewiththemachine
toenhanceandexpanditscapabilities.Contact
yourAuthorizedServiceDealerorauthorizedT oro
distributororgotowww.Toro.comforalistofall
approvedattachmentsandaccessories.
Toensureoptimumperformanceandcontinuedsafety
certicationofthemachine,useonlygenuineToro
replacementpartsandaccessories.Replacement
partsandaccessoriesmadebyothermanufacturers
couldbedangerous,andsuchusecouldvoidthe
productwarranty.
10