Service Manual

SPECIFICATIONS & MAINTENANCE
2-4
Toro 21” Aerator Service Manual
2
Fig. 004 g. 17 G023022
Adjusting the Coring Depth (All
Models)
A coring depth of 2-1/2” (6.35cm) is recommend ed, but
you can change the depth as follows:
1. Stop engine, wait for all moving parts to stop.
2. Disconnect the wire from the spark plug.
3. Loosen the nuts securing the wheel stop on the right
side of the machine (Fig. 004).
Fig. 003 g. 9 G023063
2. Secure the handle with both mounting bolts.
3. Adjust the tine-control lever.
Rear handle position - highest height
A. Trunion bracket - C. Mounting bolt location
top hole D. Handle hardware -
B. Lift link straps rear holes
A. Wheel stop C. Indicator hole
B. Nuts D. Indicator notches
A
B
D
C
C
A
C
D
B