Service Manual

CHASSIS

3-7

Toro 21” Aerator Service Manual

3. Install new cable. Install the linkage to the trans-

mission and install all of the lock nuts and tighten.

Adjust the cable as follows:

4. Adjust the traction drive cable at the lower anchor

by moving the nut to the end of the thread and

tightening the jam nut (Fig. 045).

Fig. 043 drive cable 1

2. From under the machine, loosen the cable lock nuts

and remove the linkage that connects the cable to

the transmission. Remove the cable (Fig. 044).

A. Nut B. Jam nut

Fig. 044 drive cable 2

Fig. 045 g. 30 G020484

Drive Cable Removal & Installation

1. Remove the cotter key and pin from the drive

handle. Loosen the lock nuts on the handle and

remove cable (Fig. 043).

A B