Installation Instructions

ManualsBrandsToro ManualsUtility VehicleToro 23807E

FormNo.3396-148RevB

StakeDownGuards

4045DirectionalDrill

ModelNo.23807

ModelNo.23807E

InstallationInstructions

WARNING

CALIFORNIA

Proposition65Warning

ThisproductcontainsachemicalorchemicalsknowntotheStateofCaliforniato

causecancer,birthdefects,orreproductiveharm.

Safety

SafetyandInstructionalDecals

125-6179

1.Warning—hazardarea;keepatleast3meters(10feet)

awayfromthemachinewhileinoperation.

8111LyndaleAvenueSouth

Bloomington,MN55420

Registeratwww.T oro.com.

OriginalInstructions(EN)

PrintedintheUSA

AllRightsReserved

*3396-148*B

Summary of content (4 pages)

PAGE 1
Form No. 3396-148 Rev B Stake Down Guards 4045 Directional Drill Model No. 23807 Model No. 23807E Installation Instructions WARNING CALIFORNIA Proposition 65 Warning This product contains a chemical or chemicals known to the State of California to cause cancer, birth defects, or reproductive harm. Safety Safety and Instructional Decals 125-6179 1. Warning—hazard area; keep at least 3 meters (10 feet) away from the machine while in operation.
PAGE 2
8. Loosely install the assembly to the frame using 5 bolts (M8-1 1/4 x 35 mm) as shown in Figure 2. 1 Preparing the Machine and Installing the Left Guard Parts needed for this procedure: 1 Proximity-sensor cap 1 Guard cover 1 Guard-support bracket 6 U-nut 6 Bolt (M8-1 1/4 x 35 mm) 1 Left guard 1 Bolt (M12-1 3/4 x 120 mm) 1 Locknut (M12) 1 Bolt (M8-1 1/4 x 30 mm) 1 Locknut (M8) Figure 2 1. Bolts (M8-1 1/4 x 35 mm) 9.
PAGE 3
11. Install the guard assembly onto the frame (Figure 2) using 6 bolts (M8-1 1/4 x 35 mm). 2 12. Torque the bolts to 23 to 29 N-m (17 to 21 ft-lb). 13. Install the left guard assembly using 1 bolt (M8-1 1/4 x 30 mm), 1 locknut (M8), 1 Bolt (M12-1 3/4 x 120 mm), and 1 locknut (M12) as shown in Figure 4. Installing the Right Guard Brackets Parts needed for this procedure: Figure 4 1. Bolt (M12-1 3/4 x 120 mm) 4. Bolt (M8-1 1/4 x 30 mm) 2.
PAGE 4
3 Installing the Stakedown Guard Parts needed for this procedure: 1 Stakedown guard 8 Bolt (M8-1 1/4 x 30 mm) 8 Locknut (M8) Figure 6 Procedure 1. Bolt (M12-1 3/4 x 120 mm) 4. Upper bracket, large 2. Bolt (M8-1 1/4 x 30 mm) 5. Locknut (M8) 3. Upper bracket, small 6. Locknut (M12) Rotate the hydraulic lines as needed to ensure that they do not rub on the stakedown guard assemblies. Install the stakedown guard using 8 bolts (M8-1 1/4 x 25 mm) and 8 locknuts (M8) as shown in Figure 8. 3.